惠州珑玲信息科技有限公司供应TAJIMA单头刺绣机TMBR-SC 

联系人李燕玲，联系电话13928305141，QQ：1767761209，Email：elaineli0303@sina.com

15针单头超大刺绣面积：360x500mm

最前沿技术：DCP数控压脚、多色绳绣、手绣功能等

包罗万象的成品绣花框，满足更多元化的成品刺绣需求

采用数控压布脚，轻松简单地在厚面料和皮革上刺绣

 专利数控压布脚，可根据面料厚薄程度调整，减低对所绣面料造成的压痕或损坏；同时，优化压布脚压布时间，有效防止所绣面料颤动走位，提升刺绣新标准。专利数控压布脚对应多元化各式各样面料，广泛适用于皮革、厚布料、弹性面料、绗缝夹棉类面料上。

适用行业：

潮流服装服饰店、连锁专卖店、DIY个性刺绣网店、家庭/手绣小作坊、学院/机构教学、工厂打样/小批量生产、大学生/梦想者创业

服务：

免费远程技术支援、师傅上门安装调适、师傅厂房布置店铺布置指导、专业系统的操作培训、及专业系统的制版培训、专业高难度绣花技术培训、专业高难度制版培训、阿里巴巴零配件网购、小批量辅料田岛代购、厂家直销终身服务。

Huizhou Long Ling Information Technology Co. Ltd.

Single-Head Automatic Embroidery Machine

The next generation mode with the Digitally Controlled Presser Foot "DCP"

A wide area can be secured all around the frame, It can be easily installed for quick changeover with minimal down time.

The air clamp makes large sized bags easy to embroider.

It can also embroider on slim items like socks.

What is the DCP

The machine can embroider on thick material or seamed sections without fluttering due to Tajima’s latest feature.

DCP is an abbreviation for Digitally Controlled Presser Foot. Moving “Presser Foot” to press the fabric by the motor presses surely.

As the lowest point of Presser Foot can be easily set on the operation panel according to the thickness of fabric,

There are no worries about damage to the fabric by the presser foot. And it is very efficient for 3D embroidery using urethane on cap.

The FS mode is good for loosely twisted thread

The FS mode is best suited for loosely twisted threads as it can embroider this type of fine thread with a high quality finish.

By using the FS mode exclusive parts (sold separately) a nice lofty finish can be achieved.

It can easily embroider on sleeves or pockets

With the new type slim cylinder that has been reduced by 12% in width, it is even better for working on children’s wear or smaller pockets.

Network

Embroidery data can be easily sent to the machines by connecting the embroidery software to a network.

For name tag embroidery, autograph is recommended as it simplifies the process. In addition to the DG/ML,

it allows for the smoothest design date generation and transmission to the machine.